Marvel 3SWCE - Features

20
FEATURES FOR WINE CELLARS
Figure 14
3SWCE 4 bottles of wine per rack
Insert Wine Bottles
The roll-out shelves each hold from 3 to 10 bottles per rack
depending on model. See Figure 13 to 16 for typical wine
bottle spacing. Tall bottles should not be loaded on the bot-
tom rack of the 6SDZE because they may prevent the door
from closing.
Loading Tips and Suggestions
Position white wines on the middle or lower racks and red
wines on the upper racks.
Keep wines that you plan to use for everyday drinking and
entertaining on the front half of the racks where labels are
completely visible. Place wines for aging or longer term
storing in the rear.
Roll-out Racks
The roll-out wine racks may be pulled out approximately
14 inches to facilitate adding or removing bottles. The bot-
tom rack of model 6SDZE may be pulled out approximately
8 inches. Do NOT lean on or press down heavily on the
wine shelves. Doing so may damage the shelves and the
wine bottles stored on them. Pull the wine racks out gently
and carefully to minimize unsettling your wine collection.
AVOID pulling out more than one rack at any time to
maintain stability.
Single Bottle Racks
Since bottles are not stacked on top of each other, you can
easily view and access your inventory without disturbing
other bottles.
Figure 15
6SWCE, 6OSWCE, 6SDZE
8 bottles of wine per rack
Figure 13
3SWCCE 3 bottles of champagne per rack
Figure 16
8SWCE 10 bottles of wine per rack