Mas Grup
2
Technical specifications of INM/INL type pumps
Suction Flange: DN 40-DN 250
Discharge Flange: DN 40-DN 250
Operating Pressure: 10 bar.
Operating Temperature: -25 – 120°C
Capacity: 2-800 m
3
/h
Hm: 2-100 m.
Speed: 900-3600 RPM
Product Information as per Regulation No. 547/2012 (for Water Pumps
with a Maximum Shaft Power of 150 kW) Implementing "Ecodesign"
Directive 2009/125/EC
Minimum Efficiency Index for MAS INM/INL Pump Series is shown on the
pump label.
MEI values of MAS INM/INL Pump Series are shown on the pump
characteristic curves.
Minimum Efficiency Index for MAS INM/INL Pump Series; Minimum 0.4.
(MEI≥0,4)
Efficiency values of the pump characteristic curves, which are cut
diameter, are expressed in %.
INM/INL Series water pumps, the pump efficiency can be achieved more
than fix speed in case of variable speed control.
More information about the Ecodesign can be reached at
www.europump.org
Figure 1: Pump Label
ATEX Version Pump Label
2.2. Performance Information
Actual performance of the pump can be obtained from the order page
and/or from the test report. This information is given on the pump label.
The performance curves given in the catalog are valid for water whose
density and viscosity are ρ=1 kg/dm
3
and ν=1 cst. respectively. For
those liquids whose densities and viscosities are different from those of
water, please consult with MAS DAF MAKINA SANAYI A.Ş. since the
performance curves vary with density and viscosity
Do not operate the pump with a motor that has a different power
except for the given catalog and label values.
The pump is not to be operated at off-design point given in the order and
supplied from the firm.
It is necessary to ensure that the instructions are obeyed for the safe
running of the pump.
2.3. Warranty Conditions
The entire products in our selling program are warranted by MAS DAF
MAKINA SANAYİ A.Ş.
The warranty conditions will only be valid when all the instructions about
installation and start-up operations of the pump unit are taken into
account.
2.4. Test
All Pumps are dispatched for sale when all the performance and pressure
tests are completed. Proper assurance of material and fault-free
operation of pumps whose performance tests are made is under the
warrantyof MAS DAF MAKINA SANAYI A.Ş.
2.5. Pressure Limit
Pressure at the discharge flange must not exceed 16 Bar. A special order
is necessary for applications with higher pressures.
2.6. ATEX Description
The undersigned Company certifies under its sole responsibility that the
item of equipment specified below satisfies the requirements of the ATEX
Directive 94/9/EC which is apply to it.
Please read cautiously all instructions emphasized with ATEX sign in this
manual.
ATEX Codification
ATEX -95
II 2G /D c Tx (85
o
C – 200
o
C)
To Next Page
Loading...
Need help?
General
