MASSEY FERGUSON 410 - Page 94

Maintenance and Adjustment
94
410/420/430 - 001 8903 U1
UZEL
Bulb replacement
Headlights
1. Switch off all light switches.
2. Remove the front grille (1, Fig. 138).
3. Remove the headlight wiring plug .
4. Remove the rubber surround (2).
5. Release the spring clip and remove the failed bulb
(3).
6. Fit a new 40/45 watt bulb, reassemble the light
unit and test.
Instrument panel illumination light bulbs
To renew any of the illumination lighting bulbs proceed
as follows:
1. Switch off the main lights.
2. Remove and turn the instrument over, there are
four bulbs:
a. Tractormeter illumination
b. Temperature and fuel gauge illumination
c. Digital display illumination
d. Indicator lamps illumination
3. Using a small plier first turn the bulb holder left
and then pull the failed bulb out (Fig. 139) .
4. Fit new bulbs (see the watts of the bulbs below)
in its holder, then push the bulb holder into the
instrument panel and turn it to the right.
Watts:
a.Instruments illumination - 12V - 1.2 W
b.Temperature and fuel gauge illumination-12V- 2 W
c.Digital display illumination - 12V - 0.8 W
d.Indicator lamps illumination - 12V - 1.2 W
Fig.138
ba
Fig.139
d
c
Fig.140