The first time you take both earphones out of their case they will enter pairing
mode.
STEP 1: Open the Bluetooth menu on your device.
STEP 2: Select M&D MW08.
STEP 3: (OPTIONAL) Download and open the M&D Connect app.
To manually activate pairing mode, hold down the multi-function button until the
indicator light starts pulsing/pairing tone is heard.
NOTE: If you are already connected to a device, remove the earphones from your
ears to avoid activating your voice assistant.
PAIRING
5
PULSING INDICATOR LIGHT
MULTI-FUNCTION BUTTON
ANTENNA
PROPRIETARY WIND
REJECTION MESH
Up to two devices can be connected to MW08 at one time.
1. Remove earphones from case. Press and hold the multi-function button on
right earphone to enter pairing mode. Connect to device 1.
2. Enter pairing mode again and device 1 will disconnect.
3. Connect to device 2 and place earphones in case.
4. Remove earphones from case and they will automatically connect to device
1 and 2 simultaneously.
5. Pause one device and play from the other to swap earphones connection.
MULTIPOINT
To Next Page
Loading...
