24
tighten the chuck jaws securely.
4. Tap the hex key sharply with a mallet in anti-clockwise direction. This will
loosen the chuck for easy removal.
5. Attach a new chuck to the spindle and tighten the chuck screw.
TROUBLESHOOTING
PROBLEM CAUSE SOLUTION
The drill/driver does not
work
Battery is depleted Charge the battery
Bit cannot be installed
Sleeve is not
released
Release the sleeve
Bit does not fit the
sleeve
Use suitable adapter
Motor overheating
Be sure cooling vents
are free from dust
and obstacles
Clean, clear vents. Do not
cover with hand during
operation
WARRANTY
If, during normal use, this MASTERFORCE
TM
power tool breaks or fails due
to a defect in material or workmanship within three years from the date of
original purchase, simply bring this tool and its sales receipt back to your
nearest Menards
®
retail store for a free equivalent replacement within those
three years.
The warranty:
(1) excludes expendable parts including but not limited to blades, bits, light
bulbs, and/or batteries;
(2) shall be void if this tool is used for commercial or/and rental purposes;
and
(3) does not cover any losses, injuries to persons/properties, or costs. This
warranty does give you specific legal rights and you may have other
rights, which vary from state to state.
*SAVE YOUR RECEIPTS. Your warranty is void without them. For help, please
call to our customer center, toll free number: 1-866-917-4374.
To Previous Page
Loading...