ASSEMBLY INSTRUCTIONS
1. Fix the tank tray bolt
1/4-20 x 1/2 in.
Screw
x 16
1/4-20 lock
Washer
x 16
Tank tray bolt
Remove the LP tank bolt on the cart base (W) as
shown in Fig. 1A and then reinstall as shown in
Fig. 1B.
Note: For all of the following steps, do not
tighten any screws completely until all
screws for that step have been installed.
Once all screws have been installed, then
tighten them securely.
2. Install casters
a) With the cart base (W) laying as shown in Fig. 2,
attach the 2 straight casters (Z) as shown to the left
side of the cart base (W) using 8 1/4-20 x 1/2 in.
screws (BB) and 8 1/4-20 lock washers (DD). Install
all screws first and then tighten.
b) Attach the 2 locking casters (V) to the right side
of the cart base (W) using 8 1/4-20 x 1/2 in. screws
(BB) and 8 1/4-20 lock washers (DD). Install all
screws loosely first and then tighten.
Hardware Used
8
1A
1B
2
Note: For ease of assembly, lock the 2
locking casters (V) prior to proceeding to
the next steps.
BB
DD
BB
DD
Z
W
V
8
To Next Page
Loading...
