16
NATURAL GAS CONVERSION
6. Use the 17 x 19 mm wrench (GG) to
remove the hex nut securing the
rotisserie burner orifice and hose
assembly. Detach the assembly from the
bracket. Remove the LP orifice of the
rotisserie burner with the orifice removal
tool (CC) and install the Φ1.30mm
orifice (HH). Reinstall the orifice and
hose assembly and the rear panel as
stated in Step 5.
Hardware Used
x 1
x 1
x 1
7. Re-install the burners. Make sure the
orifices are aligned with the burners and
the ignition pins are installed in their
original positions. Check for sparks
before operating your grill.
8. Put the flame tamers back in the
firebox, followed by the grids and
warming rack.
To Next Page
Loading...
Need help?
General
