Master Forge GGP-2501 - Page 23

CARE AND
MAINTENANCE
1.
Overlap 3/4" between venturi tube
and nozzle when
assembled.
2.
Keep the center line
of venturi tube
and nozzle on one line.
WARNING:
if the instructions
above are not followed,
an explosion may result,
possibly
causing
serious bodily injury
or death
with
dishwashing
detergent
and hot
water
solution. Rinse
with water
and let thoroughly
dry.
Cooking
Grids
-
The
porcela
like
composition
that should
be handled with
care
not
to. chip. Use
mild
dishwa
ng soda
and hot water
solution. Nonabrasive
scouring
powder
can
be use
nd then
rinse with water.
Heat
Shield
-
Clean residue
with wire
brush and wash
with
soapy
water.
Then rinse with
water.
Grease Collector
-
Periodically
empty
the
grease
cup
and clean with dishwashing
detergent and hot
water
solution.
Cleaning
the burner
assembly
-
Make
sure the
grill
is
cool
1. Turn
gas
off at the
control knobs and
propane
tank.
2. Remove
cooking
grates
and heat shield.
3. Remove
grease
collector.
4 Remove
burner by unscrewing nui
from
beneath burner "foot" using a
screwdriver and
pliers.
5. Lift
burner up and away from
gas
valve orifice.
6. Clean inlet
(venturi)
of burner with
small bottle brush
or compressed air.
7. Remove
all food residue
and dirt on outside
of burner surface.
B. Clean
any clogged
ports
with
a stiff wire
(such
as an opened
paper
clip).
9. lnspect
burner for
any damage
(cracks
or holes). lf damage
is found, replace with new
burner.
Reinstall burner;
check to ensure that
gas
valve
orifices are correctly
positioned
inside burner inlet
(venturi).
22