OPERATION INSTRUCTIONS
Lighting Burner With A Match:
1. Place
a
match in the
end of
the match holder
that
is
pre-installed
on the sides of
grill
housing.
Once
lit,
immediately
place
the
flame through
the
hole as shown
near the burner
ports.
2- Press in knob and rotate counterclockwise to High
setting and burner should light immediately. lf more
than
one burner is desired, turn other knobs to
"on"
positions
after
first
burner
is lit.
3. Adjust burners to desired cooking settings.
Observe Flame Height When lit: Flame
should be a blue /
yellow
color
between 1- 2 in. high.
Good
Bad
CARE AND MAINTENANCT
CAUTION:
All cleaning and maintenance should be done when
grill
is cool and with the
gas
supply turned off at
the
propane
cylinder.
DO NOT
clean any
grill part
in a self-cleaning oven. The
extreme
heat will damage the finish.
Clean
ing
Burning off the
grill
after every use
(approx.
15 minutes) will keep
excessive
food
residue from
building up. To
"Burn
Off'
or heat clean
your grill,
turn the 3 main burners to HIGH and run for
'15
minutes with
the
lid
closed.
Then
use a wrre brush to clean the
grids.
Recommended
cleaning
materials
-
Mild dishwashing
liquid
detergent,
hot water, nylon
cleaning
pad,
wire brush
DO NOT use cleaners that contain acid, mineral spirits or xylene.
Outside surfaces
-
Use ONLY
mild dishwashing detergent and hot water
solution
to
clean, and then
rinse wrth
water.
lf the inside surface
of
the
grill
lid has
the appearance of
peeling paint,
baked on
grease
buildup
has
turned to carbon and is
flaking
off. Clean thoroughly with strong
solution of detergent and hot water.
Rinse
with water
and allow to completely dry.
lnterior of
grill
bottom
-
Remove residue
using brush, scraper and/or cleaning
pad,
and then wash
21
To Next Page
Loading...
