SET YOUR OWN COMBINATION LOCK
3
4
90˚
2
90˚
Top View
5
90°
Align with
this notch
1
Transportation Security Administration (TSA) baggage screeners are
trained to recognize the Travel Sentry
™
logo on TSA - accepted
locks. They have access to a secured set of codes and tools which
allow them to open, inspect and relock baggage which is locked
with a TSA – accepted lock.
Your new lock is preset at the factory to unlock at 0-0-0-0. Make
sure you are able to open and close the lock prior to setting your
own combination. Carefully follow each step to ensure proper
setting procedures.
1. Adjust dials so the preset factory combination of 0-0-0-0 appears
clearly in the “windows”.
2. Pull shackle straight up and rotate it 90° counter clockwise
so the notch on the shackle aligns with the notch in the
lock body.
3. Firmly press shackle down into the body of the lock and rotate
it counter clockwise an additional 90°. The shackle should be
pushed securely inside the body of the lock so it will not come out.
4. Set the 4 dials to any combination you choose. Make sure
each number appears clearly in the window.
5. Rotate the shackle 90° clockwise, then lift and rotate it an
additional 90° and insert it into the shackle collar. Scramble the
dials. The lock is now ready to be used with your new combination.
Store your combination at masterlockvault.com. To change the
combination again, repeat steps 1 – 5.
Lift
90°
© 2015 Master Lock Company LLC
Milwaukee, Wisconsin 53210 U.S.A.
www.masterlock.com
Press
Down
2
3
4
1
0
0
0
0
Store your
combination at
masterlockvault.com
4696D Instructions
To Next Page
Need help?
General
