9. Save your combination in a safe place or record it below.
You can also store it at: www.masterlockvault.com.
To reset the combination again, repeat steps 1 – 9.
1. Squeeze the shackle firmly toward the lock twice and release to “clear” the lock
each time before opening it.
2. Enter the combination by sliding the button to each position in the combination pattern.
Note: Be sure to slide the button all the way in each direction, guiding the button back to
the center position before moving to the next position.
3. Pull up on the shackle to open the lock.
4. To close the lock, insert the shackle and squeeze firmly.
IMPORTANT: ALWAYS REPEAT STEP 1 EACH TIME YOU OPEN THE LOCK!
HOW TO CHANGE THE COMBINATION
You can set your combination to any pattern of any length. For extra security, it is best to create a longer
combination using several of the up, down, left and right positions. Write the combination down once you
change it! FOLLOW INSTRUCTIONS EXACTLY!
HOW TO OPEN
1500iD Speed Dial
™
Instructions - video at: www.masterlock.com
1. Place lock in the
open position.
2. On the back of the lock, use
a pointed object to slide the
reset lever into the “up”
position (toward the “R”).
3. IMPORTANT: INSERT THE
SHACKLE INTO THE LOCK
AND SQUEEZE FIRMLY
TWICE TO “CLEAR” IT
4. Pull up on the
shackle to open
the lock.
5. Enter your new
combination.
6. Slide the reset lever back to
the “down” position.
7. Insert the shackle
into the lock and
squeeze firmly.
8. The lock will now open
with your new combination.
Remember to squeeze the
shackle firmly toward the
lock twice and release to
“clear” the lock each time
before opening it.
Squeeze Twice
Squeeze
Twice
HOW TO REMOVE LOCK FROM PACKAGE
1. Cut through card back along dotted lines at the bottom; insert a sharp object
to pull the plastic drawer toward you; remove the folded instruction sheet.
2. The preset combination for your lock appears on your instruction sheet as
a series of 4 up/down/left/right arrows like the example below.
Cut
Here
Cut
Here
Pull out plastic drawer,
remove instructions
Instruction
Tag Example
Preset combination example of
Down, Right, Left, Right
To Next Page
Need help?
General
