800.825.5397
15
PREPARING SPRAYER
• Review Safety Information: Review safety information in this manual
and manufacturer chemical label before use.
• Sprayer Attachment: Ensure the sprayer is securely attached to a
vehicle if using trailer hitch for spraying.
• Empty Tank: Ensure the sprayer has been thoroughly flushed and
drained of all residual chemical prior to uses.
• Inspect & Test: Inspect the tank and components for any cracks or
leaks. Replace any damaged parts. IMPORTANT: After any repair, ALWAYS
test for leaks with water one final time before use.
• Check Drain Cap: Before filling tank, ensure drain cap at bottom of tank
is securely tightened.
• Protective Equipment: ALWAYS wear protective equipment as directed
on the chemical label.
• Assess Wind & Area Conditions: Before spraying, determine if wind
conditions are suitable. DO NOT spray if wind speeds are greater than 4
MPH. DO NOT spray if bystanders are in the intended area and verify that
area is in a well-ventilated outdoor area.
• Power Off: Before filling tank, make sure power to the sprayer and the
vehicle is off and brakes are set to prevent unintended movement.
• Filling Tank: Remove sprayer tank lid and add chemical/water dilatation
ratios that are called out by chemical label. Ensure chemical is thoroughly
mixed with a stirring device and then securely thread tank lid back on
sprayer tank.
USING SPRAYER
To Next Page
Loading...
