46DO NOT DIVE.
INITIAL SWIM SPA SETUP
To relieve an airlock situation,
loosen the pump union on
the discharge of the pump.
This pump union is indicated
by an arrow in the picture.
Water should leak out of the
union once the air has been
removed. Tighten the union
and test the pump for proper
operation. Repeat this process
if needed.
6. Be sure the jets in your swim spa are open.
7. Adjust water chemistry according to the instructions provided in the Water Maintenance
section.
8. Your swim spa water will heat approximately 1°F (0.5°C) per hour, on average, with the cover
closed on the swim spa. Times may vary. This varies depending on the size of the swim spa
and ambient temperatures.
WATCH HOW-TO VIDEOS:
masterspas.com/video-tutorials
WATCH HOW-TO VIDEOS:
masterspas.com/video-tutorials
Airlock
Airlock
Pump Union
Slice Valve
To Next Page
Loading...
