33DO NOT DIVE.
CARE OF LAMINAR FLOW JETS:
In order to keep your Laminar Flow Jets operating properly, follow these steps:
1. Turn off Laminar Flow Jets.
2. Remove outer ring by turning face
counter-clockwise while pulling on it.
3. Either the whole Laminar Flow Jet Assembly pops out: Rinse it out and inspect it.
Or, if only the outer ring comes off: Remove internal Jet insert with a pair of needle nose pliers
and inspect it.
4. Clean plastic diffuser at the back of the Jet insert or Laminar Flow Jet Assembly so all holes are
free of debris.
5. Reinstall Jet insert or assembly and outer ring by pushing it in and turning it clockwise until it
stops.
REGULAR MAINTENANCE PROCEDURES
NOTE: To prevent premature failure of your spa cover and the possibility of water running out of
the spa off the bottom of the cover, always turn Laminar Flow Jets down so that they do
not hit the cover when the cover is closed. You do not want to completely turn jets off.
Doing so may cause a build up of stagnant water in the water line if not used often.
NOTE: These maintenance procedures are the responsibility of the spa owner to perform. These
procedures are not covered by the spa warranty.
EN 17125, Do not put finger in massage jet
OR
To Next Page
Loading...
