Master Spas SEATTLE - Model Specifications

40DO NOT DIVE.
MODEL SPECIFICATIONS
Model Listing
Number
Spa Dimensions
(cm)
Electrical Requirements
1
Seating Capacity
2
Water Capacity
3
litres)
Dry Weight
4
(kilos)
Full Weight
3,4
(kilos)
Therapy
Pumps
Control System
SEATTLE
6200
199 x 199 x 87
*240V, 32A
5 946 381 1746
2 MS6013XE
BOSTON
5300
214 x 214 x 92
*240V, 32A
6 1211 420 2134
2 MS6013XE
GRAND CANYON
8000
226 x 226 x 92
*240V, 32A
6 TBC TBC TBC
2 MS6013XE
SANTA BARBARA
5500
239 x 214 x 97
*240V, 32A
5 1173 465 2059 3
MS6013XE
1
See Electrical Requirements section for further details.
2
Total bather capacity in spa. The number of bathers in spa should never exceed indicated seating capacity. Depending on
spa size, water level and bather displacement; full seating capacity may not be achievable. Do not allow additional bath-
ers to enter if bather displacement results in water levels overflowing or reaching the spa controls (air controls, diverters,
spa topside control and etc.) as this will result in water leaking out of the spa shell and potentially in to the equipment
area.
3
Full weight based on dry weight of spa, max seating capacity of spa, assumed average weight per person of 185 pounds
and estimated water weight of 8.34 pounds per gallon. Rounded up in increments of 5.
4
Manufacturing tolerances along with other factors can result in variance in actual spa weight. If weight is a critical figure
necessary for delivery, or final installation, we suggest a minimum of 15% be added to the listed weight when planning
delivery or installation.
* Default Minimum Electrical Requirement as Configured from Manufacturing. See Electrical Requirements Section for
Electrical Hook-Up by Control System.
Note, there is no INT TS120 model.