Masterbuilt MB20010118 User Manual

11
• Add water to the MAX fill line. Do not add water above this line. Do not allow
water to completely evaporate. This will cause the element to overheat and
damage the appliance. Make sure the basket is in place.
• Water will boil at 212°F (100°C). When steaming or boiling, turn dial to
375°F (191°C) to ensure the appliance will not cycle and water will continue
boiling.
Operating Instructions
HOW TO STEAM
E
E
SECTION
E-E
MAX FILL
LINE
ELEMENT
• The valve must be in the OFF position.
• Remove the safety cap on the drain valve.
• Screw the valve spout attachment onto the drain valve. Do not overtighten.
This could damage the threads and cause leakage. If the spout becomes
snug in the up position, turn counterclockwise until it is in the down
position.
• Alight the spout over a container with the opening facing downward. Open
the valve to drain. Close the valve when completely drained.
• Do NOT store water in the appliance.
DRAIN VALVE
VALVE SPOUT
DRAIN
VALVE
• Your appliance is equipped with an overheat safety feature.
• If the appliance overheats it will shut off automatically.
• To reset the appliance, unplug from the outlet and remove the control panel. Insert
a toothpick into the small hole on the inside of the control panel and push the
button. This will reset the appliance.
RESET FUNCTION
RESET
BUTTON
• Cavities in the appliance are designed to catch grease and
condensation from steam. Wipe out the cavities with a damp
cloth after each use.
• When steaming, the cavities may become full before cooking
is finished. Drain with a sponge or other absorbent material.
CAUTION! Water will be hot.
CAVITIES
CAVITIES

Masterbuilt MB20010118 Specifications

General

Brand	Masterbuilt
Model	MB20010118
Category	Fryer
Language	English