40
1. Disconnect LP gas cylinder and place at least 8 m away from unit.
2. Fill flame disk bowl with up to 1.4 kgs of charcoal. Stack charcoal in a pyramid.
3. Add lighter fl uid following directions on fl uid container. Before lighting, place lighter fl uid at least 8 m
away from unit. Do not lean into unit when lighting charcoal. Light charcoal. LEAVE DOOR OPEN.
4. In about 15 minutes, fl ames will die out and charcoal will begin to ash over. Charcoal should be kept
red hot for at least 30 minutes prior to use. Once the charcoal is completely ashed over, spread
charcoal in a single layer. Do not cook before the charcoal has a coating of ash.
• WARNING! Do not use spirit or petrol for lighting or re-lighting! Use only fi relighters complying to EN
1860-3!
• Overfi lling fl ame disk bowl can cause serious injury and damage the unit.
• Never add additional lighter fl uid once charcoal has ignited.
• Hot coals should not be left unattended.
Operating Instructions - Charcoal
IGNITION INSTRUCTIONS
To Next Page
Loading...
