Extension cord safety
WARNING: Keep the extension cord clear of the working area. Position the cord
so it will not get caught on the workpiece, tools or any other obstructions while you are working with the
power tool.
Make sure any extension cord used with this tool is in good condition. When using an extension cord, be
sure to use one of heavy enough gauge to carry the current the tool will draw. An undersized cord will
cause a drop in line voltage resulting in loss of power and overheating.
The table below shows the correct size to use according to cord length and nameplate ampere rating. If
in doubt, use the next heavier gauge. The smaller the gauge number the heavier the cord.
Be sure your extension cord is properly wired and in good condition. Always replace a damaged
extension cord or have it repaired by a qualied electrician before using it. Protect your extension cord
from sharp objects, excessive heat and damp or wet areas.
Use a separate electrical circuit for your power tools. This circuit must not be less than 14 gauge wire
and should be protected with either a 15 A time delayed fuse or circuit breaker. Before connecting the
power tool to the power source, make sure the switch is in the OFF position and the power source is the
same as indicated on the nameplate. Running at lower voltage will damage the motor.
SAFETY GUIDELINES
SAFETY GUIDELINES
10
Keep the impact wrench handle and body clean and free of oil and grease. Always use a clean dry cloth
when cleaning. Do not use solvents, brake uid, gasoline or other petroleum products to clean the tool.
They will damage the tool.
Do not wear neckties or loose clothing.
When wearing gloves, they must be tight tting and slip resistant type. Leather gloves offer the best
protection.
Always use two hands when operating the impact wrench. Use one hand on the handle and the other on
the front of the tool body.
Never place your hand so it is touching the socket or accessory when the tool is turned ON. Your hand
could be seriously injured.
Always remove the plug from the power source before installing or removing any socket or accessory.
Be ready for components to shift when removing any fastener. The speed of the fastener removal could
cause unexpected shifting of the components.
IMPACT WRENCH 054-1216-4
MINIMUM GAUGE (AWG) EXTENSION CORDS (120 V use only)
Amperage rating Total length
More
than
Not more
than
25'
(7.5 m)
50'
(15 m)
100'
(30 m)
150'
(45 m)
0 6 18 16 16 14
6 10 18 16 14 12
10 12 16 16 14 12
12 16 14 12 Not Applicable
11
IMPACT WRENCH 054-1216-4
To Next Page
Loading...
Need help?
General
