CHARGING THE BATTERY PACK
WARNING: Only use the charger
supplied with this tool or a
PowerXchange diagnostic charger to
charge the following Mastercraft
batteries:
● 18 V Ni-Cd #054-3102-2
● 18 V Lithium-ion #054-3100-6
Charging any other batteries may damage
the charger, and possibly cause serious
injury.
1. To charge the battery, place the
charger (1) in a dry location near a
120 V, 60 Hz electrical outlet
(Fig. 1).
2. Place the battery stem (2) into the
matching cavity (3) in the top of the
charger.
NOTE: Make sure the battery stem is
pressed fully into the charger as far as it
will go.
3. Plug the battery charger into the
120 V, 60 Hz wall receptacle.
NOTE: Do NOT charge batteries when the
work area or the battery temperature is at
or below 0°C (32° F) or above
45°C (113° F).
When the battery charger is plugged into a
“live” receptacle, the battery charger will
begin charging the battery. The red LED
(4) and the green LED (5) on the top of the
charger will indicate the charging status
(Fig. 2).
To Next Page
Loading...
Need help?
General