Rating 120 V, 60 Hz, AC
Amperes 12.5 A
Temperature rating 250°C/450°C (482°F/842°F)
Switch 3 position rocker
TECHNICAL SPECIFICATIONS
4
Power tool safety
WARNING: To avoid electrical hazards, re hazards or damage to the heat gun,
use proper circuit protection.
The heat gun is wired at the factory for 120 V operation. It must be connected to a 120 V, 15 A
time delayed fuse or circuit breaker. To avoid shock or re, replace power cord immediately if it is
worn, cut or damaged in any way.
ALWAYS WEAR EYE PROTECTION THAT CONFORMS WITH CSA REQUIREMENTS or
ANSI SAFETY STANDARD Z87.1
FLYING DEBRIS can cause permanent eye damage. Prescription eyeglasses ARE
NOT a replacement for proper eye protection.
WARNING: Use protective gloves to protect your hands from burns.
WARNING: Always wear a dust mask designed to protect you from dust
created by your power tool.
WARNING: Some dust created by power sanding, sawing, grinding, drilling and
other construction activities contains chemicals known to cause cancer, birth defects or other
reproductive harm. Some examples of these chemicals are:
• Lead from lead-based paints
• Crystalline silica from bricks, cement and other masonry products
• Arsenic and chromium from chemically-treated lumber
Your level of risk from these exposures varies, depending on how often you do this type of
work. To reduce your exposure to these chemicals, work in a well-ventilated area and work
with approved safety equipment such as dust masks that are specially designed to lter out
microscopic particles.
WARNING: Use hearing protection, particularly during extended periods of
operation of the tool or if the operation is noisy.
SAVE THESE INSTRUCTIONS FOR REFERENCE
SAFETY GUIDELINES
5
HEAT GUN 054-1252-6
HEAT GUN 054-1252-6
To Next Page
Loading...
Need help?
General
