MasterCraft 054-4892-4 User Manual

headline bars
continuation tabs
notes
warnings
17
MAINTAIN TOOLS WITH CARE
OPERATING INSTRUCTIONS
Accessory
Description
Soft wood
Hard
wood
Plastic Steel
Aluminum,
brass, etc.
Shell,
stone
Ceramic Glass
Grinding disc
15000-32000 15000-32000 8000-15000 15000-32000 18000-22000 15000-32000 15000-32000 /
Cutting disc 15000-32000 15000-32000 8000-15000 15000-32000 18000-22000 15000-32000 15000-32000 /
Diamond grinding bits 15000-32000 15000-32000 15000-32000 15000-32000 18000-22000 15000-32000 15000-32000 /
Sanding paper 15000-32000 8000-15000 8000-17000 15000-32000 18000-22000 15000-32000 15000-32000 /
HSS twist drill bits 15000-32000 15000-32000 8000-15000 / 12000-17000 / / /
HSS cutter 15000-32000 15000-32000 8000-15000 8000-15000 12000-17000 / / /
Bristle brushes 8000-15000 8000-15000 8000-15000 12000-15000 12000-15000 / / /
Stainless brushes 8000-15000 8000-15000 8000-15000 8000-15000 / / / /
Brass brushes 8000-15000 8000-15000 / 8000-15000 8000-15000 8000-15000 / /
Cloth wheel / / 12000-22000 15000-32000 12000-22000 15000-32000 12000-22000
12000-
22000
Wool polishing wheel / / 12000-17000 12000-17000 12000-17000 15000-32000 12000-17000
12000-
17000
Rubber wheel / / / 15000-32000 18000-22000 15000-32000 15000-32000
15000-
32000
USING ACCESSORIES
The chart below lists the description, working speed and scope for some of the small articles supplied together with
the tool by category. To achieve best performance of the tool, it is strongly recommended that you read it before
operation, failure to adhere to this may cause accessories to fail.
WARNING: Always wear eye protection. Insert the shaft fully into the collet.
PICTURE DESCRIPTION SPEED REQUIRED INTENDED USE
Grinding bits Full speed
30,000 RPM
Metal
Mild steel
HSS (high-speed steel)
cutter
Full speed
30,000 RPM
Wood
Zinc
Plastic
Nickel
Copper
Mild steel

MasterCraft 054-4892-4 Specifications

General

Brand	MasterCraft
Model	054-4892-4
Category	Power Tool
Language	English