ORBITAL JIGSAW WITH LASER LINE - 054-8223-4ORBITAL JIGSAW WITH LASER LINE - 054-8223-4
21 22
WARNING!
When servicing, use only identical replacement parts. The use of any other parts may
create a hazard or cause damage to the product.
WARNING!
Use only accessories that are recommended for this jigsaw by the manufacturer.
Accessories that may be suitable for one tool may cause a hazard when used on another
tool.
WARNING!
Maintain tools with care. Keep cutting tools sharp and clean. Properly maintained tools with
sharp cutting edges are less likely to bind, and are easier to control.
WARNING!
If the power cord is damaged, it must be replaced with an identical replacement part and
be installed by an authorized service technician.
WARNING!
In order to ensure safety and reliability, all repairs should be performed by a qualified
service technician.
PROBLEM POSSIBLE CAUSES SOLUTIONS
The jig saw does not work. The saw is not connected to a power source Connect the plug to a power source
The blade binds or smokes
from friction.
Blade is dull. Replace the blade.
Workpiece is not properly supported. Clamp the workpiece correctly and tightly.
Incorrect blade is being used. Use the correct blade.
Iftheproblemremainsunsolvedafterperformingthechecksdescribedabove,callthetoll-
freehelpline,at1-800-689-9928.
TROUBLESHOOTING
MAINTENANCE
To Next Page
Loading...
Need help?
General
