Prevent unintentional starting. Ensure the switch is in the Off-position before
Carrying power tools with your nger on the switch or energizing power tools that have the
switch on invites accidents.
Remove any adjusting key or wrench before turning the power tool on. A wrench or a
key left attached to a rotating part of the power tool may result in personal injury.
Do not overreach. Keep proper footing and balance at all times. This enables better
control of the power tool in unexpected situations.
Dress properly. Do not wear loose clothing or jewelry. Keep your hair, clothing and
gloves away from moving parts. Loose clothes, jewellery or long hair can be caught in
moving parts.
If devices are provided for the connection of dust-extraction and dust-collection
facilities, ensure these are connected and properly used. Dust collection can reduce dust-
related hazards.
POWER TOOL USE AND CARE
Do not force the power tool. Use the correct power tool for your job. The correct power
tool will do the job better and safer at the rate for which it was designed.
Do not use the power tool if the switch does not turn it On and Off. Any power tool that
cannot be controlled with the switch is dangerous and must be repaired.
before making any adjustments, changing accessories, or storing power tools. Such
preventive safety measures reduce the risk of starting the power tool accidentally.
SAVE THESE INSTRUCTIONS FOR REFERENCE
8
Store idle power tools out of the reach of children and do not allow people unfamiliar
with the power tool or these instructions to operate the power tool. Power tools are
dangerous in the hands of untrained users.
Maintain power tools. Check for misalignment or binding of moving parts, breakage of
parts and any other conditions that may affect the power tool’s operation. If damaged,
have the power tool repaired before use. Many accidents are caused by poorly maintained
power tools.
Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting
edges are less likely to bind and are easier to control.
Use the power tool, accessories and tool bits etc. in accordance with these instructions,
taking into account the working conditions and the work to be performed. Use of the
power tool for operations different from those intended could result in a hazardous situation.
Hold power tools by insulated gripping surfaces when performing an operation where
the cutting tool may contact hidden wiring or its own cord. Contact with a “live” wire will
make exposed metal parts of the tool “live” and shock the operator.
SERVICE
replacement parts. This will ensure that the safety of the power tool is maintained.
SPECIFIC SAFETY RULES
WARNING: Know your chop saw. Do not plug the chop saw into the power
source until you have read and understood this manual. Learn the tool’s uses and
Following these
rules will reduce the risk of electric shock, re, or serious injury.
Always wear eye protection. Any power tool can throw foreign objects into your eyes and
cause permanent eye damage. ALWAYS wear safety goggles (not glasses) that comply with
ANSI safety standard Z87.1. Everyday glasses have only impact-resistant lenses. They ARE
NOT safety glasses.
SAVE THESE INSTRUCTIONS FOR REFERENCE
To Next Page
Loading...
Need help?
General
