MasterCraft 058-0051-2 User Manual

headline bars
continuation tabs
notes
warnings
7
headline bars
continuation tabs
notes
warnings
model no. 058-0051-2 | contact us 1-800-689-9928
6
SAFETY GUIDELINES
• Paints and solvents may be harmful or fatal if swallowed or inhaled. Avoid prolonged skin
contact with solvents or paints as they will irritate skin. After any contact, immediately wash off
exposed area with hot, soapy water.
• Always shut off air supply, drain hose of air pressure and disconnect air supply when not in
use, before changing accessories or when making repairs. Turn off and detach the air supply,
safely discharge any residual air pressure, and release the throttle and/or turn the switch to its off
position before leaving the work area.
• Useonlyaccessoriesidentifiedbythemanufacturerforthespecifictoolmodel.
• Whenservicingatool,useonlyidenticalreplacementpartsand/orauthorizedparts.
• Useonlylubricantssuppliedwiththetoolorspecifiedbythemanufacturer.
• Storethetooloutofreachofchildrenandotheruntrainedpersonswhenitisidle.
• CAPROP65: This product contains chemicals known to the state of California to cause cancer and
birth defects or other reproductive harm. Wash hands after handling.
WARNING!
•Readallsafetywarningsandinstructions.Failuretofollowthewarningsandinstructionsmayresultinpersonalinjuryand
property damage. Save all warnings and instructions for future reference.
•Neversprayflammablematerialsinvicinityofopenflameornearignitionsources.Neverstoreflammableliquidsorgases
near air compressor.
•Neverspraycloserthan3'(1m)totheaircompressor.Neversprayintothecompressor,compressorcontrolsorthemotor.
CAUTION!
The warnings, precautions, and instructions discussed in this instruction manual cannot cover all possible conditions and
situations that may occur. It must be understood by the operator that common sense and caution are factors which cannot
be built into this product, but must be supplied by the operator.
KEY PARTS DIAGRAM
No. Description
G Finger lever
H Needle chucking nut
I
Glass jar with lid and fluid connector
(22 cc)
J Glass jar with lid (22 cc)
K Air inlet
B
I
J
E
F
A
H
K
C
D
G
WARNING!
If any part is missing or damaged, do not use the product until the missing or damaged part has been replaced.
KEY PARTS DIAGRAM
No. Description
A Air brush
B Nozzle
C Fluid needle
D Housing
E Protective cap
F Adjustment screw

MasterCraft 058-0051-2 Specifications

General

Brand	MasterCraft
Model	058-0051-2
Category	Paint Sprayer
Language	English