MasterCraft 058-8179-2

OPERATING INSTRUCTIONS
19
AIR-POWERED COIL ROOFING NAILER 058-8179-2
Nail depth adjustment
The Mastercraft
®
Air-powered Coil Roofing
Nailer has a depth adjustment dial below the
trigger to adjust the firing depth of the nails.
Note: Refer to the graphic imprinted below
the trigger and adjust the firing depth
accordingly
(fig J) .
CAUTION!
Potential hazard that may result in moderate injury or damage to
equipment.
• If the trigger is pressed a second time, the recoil of the nailer may lift the
safety stand enough to allow a second nail to be fired, even if the operator
has not lifted the tip of the safety stand.
• Operate the tool with the utmost care when it is connected with the air
compressor. Failure to comply may result in moderate injury or damage to
equipment.
MC-588179-12
fig J
DECREASING NAIL DEPTH
INCREASING NAIL DEPTH
Turn the depth adjustment dial
counterclockwise direction (with the discharge
area of the tool facing away from the operator)
(fig K) .
Turn the depth adjustment dial clockwise
direction (with the discharge area of the tool
facing away from the operator)
(fig L) .
MC-588179-13
fig K
MC-588179-14
fig L