7
AIR-POWERED CLIPPED-HEAD FRAMING NAILER 058-8434-4
WARNING!
Potential hazard that could result in serious injury or loss of life.
• Do not allow unskilled or untrained individuals to operate the Air-powered
Clipped-Head Framing Nailer.
• Do not use the Air-powered Clipped-Head Framing Nailer for any task other
than that it is designed to perform.
• Do not use the Air-powered Clipped-Head Framing Nailer unless it has been
instructed to use.
• L
ocate the compressor in a well-ventilated area for cooling, at a minimum of
12" (31 cm) away from the nearest wall.
• P
rotect the air hose and the power cord from damage and puncture. Inspect
t
hem for weak or worn spots every week, and replace them if necessary.
• A
lways wear hearing protection when using the air compressor. Failure to do
so may result in hearing loss.
• D
o not carry the compressor while it is running.
• D
o not operate the compressor if it is not in a stable position.
• D
o not operate the compressor on a rooftop or an elevated position that
could allow the unit to fall or be tipped over.
• A
lways replace a damaged gauge before operating the unit again.