This lightweight Mastercraft® Air-powered Clipped-head Framing Nailer drives 2 - 3 1/2" (50 to 90
mm) long clipped-head framing nails.
ACCEPTABLE NAILS
This nailer can be used with a variety of shank types (e.g. ring, smooth, spiral) and a variety of
coatings or nail compositions (e.g. Electro, mechanical, hot-dipped galvanized or stainless steel,
etc.).
Length: 2 - 3 1/2
"
(50 to 90 mm) (Fig A)
Angle: 34°
(Fig B)
WARNING!
Potential hazard that could result in serious injury or loss of life.
• The use of any other types of nails will cause the nailer to jam and could lead
to serious injury.