headline bars
continuation tabs
notes
warnings
headline bars
continuation tabs
notes
warnings
10
model no. 062-3593-2 | contact us 1-800-689-9928
SAFETY GUIDELINES
WIRE SIZE
• Consult a qualified electrician for proper wire size.
PRE-OPERATION: CHECK VOLTAGE AND PHASE
• Before operating pump, check to make sure that the voltage and phase information
stamped on the pump’s identification plate matches the available power.
IDENTIFICATION PLATE
• Note the numbers on the pump’s identification plate and record at the end of the manual
for future reference.
INSULATION TEST
• Before the pump is put into service, an insulation (megger) test should be performed on it.
The ohm values as well as the volts and amps should be recorded.
PUMP TEST
• After the pump has been properly wired and primed, it is advisable to check the system
by filling with liquid and allowing the pump to operate through its pumping cycle.
• An automatic pressure controller has been installed on the pump. The automatic pressure
controller allows for automatic operation.
MAINTENANCE
• No other maintenance is required.
SAFETY GUIDELINES
To Next Page
Loading...
