9
ASSEMBLY INSTRUCTIONS
20
STEP 8 ASSEMBLE THE DRAWERS
19
NOTE: Make sure your platform is free of debris or the drawer bottom is protected before
laying the drawer on its bottom.
Lay the drawer panel (17) on its bottom.
•
•
Bend up the side panels upright to 90°. During this process, insert the clips at the two ends
of the back panel into the slots of the side panels.
Bend all the clips towards the back panel until they lean against the back panel.
•
Place the cabinet on a flat floor against a wall. Use a power drill to attach the cabinet to the
wall with two M6 x 40 hex tapping bolts (19) through the holes at the back top beam (20).
Tighten securely. For safety, the bolts should be drilled into the studs of the wall.
STEP 7 SECURE THE CABINET TO WALL
17
1 2
3
4
drawer back
To Next Page
Loading...
Need help?
General
