Step 11: Insert Drawers.
WARNING: Pull out the ball bearing track towards you.
NOTE: Once you insert the drawers, tighten the screws for
(#48-1) Small Drawer Middle Support, (#48-2) Small Drawer
Left Support and (#48-3) Small Drawer Right Support.
Step 12: Place (#18) Drawer Mats and (#18-1) Top Cantilever Shelf Mat.
Pull out the drawer sliders and inner ball bearing track
completely. Then attach and fit the drawer to the inner track
of the sliders and slide drawers in (Fig L).
A). After sliding in the two drawers, place (#18) Drawer Mats inside the
drawers or you can place the (#18) Drawer Mats inside the drawers
before you slide them in (Fig M).
B). Place the (#18-1) Top Cantilever Shelf Mat in place (Fig M).
Step 13. Work centre is ready for use (Fig N).
Stainless Steel Maintenance
A fingerprint-resistant finish has been applied to these
parts. Do not use traditional stainless steel cleaners on
this unit. Lightly wipe off once a month with clean warm
water and a soft cloth (preferably a micro fibre cloth).
This is the safest formula to prevent new stains from
appearing over time and manage unwanted fingerprints
or grease marks. Remember to always wipe in the
direction of the surface grain (NEVER ACROSS) and
always use a lint-free cloth. Once the surface is clean,
thoroughly wipe dry with a soft absorbent cloth.
FINGERPRINT-RESISTANT SURFACES AND INCREASED
DURABILITY
track towards you.
Fig L
Fig M
Fig N
11
To Next Page
Loading...
Need help?
General
