A
B
Step 1: Install (#5-B) Leg Piece.
Fig B
Fig A
Step 2: Install (#48-1) Small Drawer Middle Support,
(#48-2) Small Drawer Left Support, (#48-3) Small Drawer
Right Support.
A: Open the package, and put the parts aside. Then, attach the (#47) "L" Bracket to the (#5-B) Leg Piece, use (#50)
Screw I to tighten. Repeat Step A to install (#47) "L" Brackets to another (#5-B) Leg Piece.
Note: Tighten all the screws after the (#47) Brackets are flush with the (#5-B) Leg Piece.
B: Attach the (#5-B) Leg Pieces to the back of the (#1) Solid Hardwood Board Top, line up the screw holes, use (#50)
Screw and (#21) Screwdriver to tighten (Fig A).
Note: Assemble the work centre on top of the cardboard packaging to help avoid scratching the solid hardwood top.
Attach the (#48-1) Small Drawer Middle Support to the
back of (#1) Solid Hardwood Board Top Back, line up
the screw holes, use (#50) Screw and (#21).
Screwdriver to tighten.
Repeat this step to install (#48-2) Small Drawer Left
Support and (#48-3) Small Drawer Right Support
(Fig B).
NOTE: Do not fully tighten the screws. This will help
you make any adjustments for alignment.
To Next Page
Loading...
Need help?
General
