headline bars
continuation tabs
notes
warnings
headline bars
continuation tabs
notes
warnings
headline bars
continuation tabs
notes
warnings
headline bars
continuation tabs
notes
warnings
headline bars
continuation tabs
notes
warnings
headline bars
continuation tabs
notes
warnings
8
model no. 054-6821-2 | contact us 1-800-689-9928
SAFETY GUIDELINES
ADDITIONAL SAFETY GUIDELINES FOR THE ROUTER
• The label on your tool may include the following symbols. The symbols and their
definitions are as follows:
V ..................... Volts
A ..................... Amperes
Hz ................... Hertz
W .................... Watts
min ................. Minutes
................. Alternating current
n
0
................... No-load speed
............... Class II Construction
…/min or …min
-1
.............. Revolutions or reciprocations per minute
.............. WARNING–To reduce the risk of injury, user must read instruction manual.
.............. WARNING–To reduce the risk of injury, always wear eye protection.
.............. WARNING–To reduce the risk of injury, always wear ear protection.
• Always make sure the work surface is free from nails and other foreign objects. Cutting into a nail
can cause the bit and the tool to jump and damage the bit.
• Never hold the workpiece in one hand and hold the tool in the other hand when in use. Never
place hands near or below the cutting surface. Clamping the material and guiding the tool with
both hands is safer.
• Always wear safety goggles and dust mask. Use only in well ventilated area. Using personal
safety devices and working in safe environment reduces risk of injury.
• Keep handles dry, clean and free from oil and grease. Slippery hands cannot safely control the
power tool.
• Never start the tool when the bit is engaged in the material. The bit cutting edge may grab the
material causing loss of control of the cutter.
• The router may make a big noise during routing; it is better to wear ear protection during the
operation.
To Next Page
Loading...
Need help?
General
