MasterCraft 2014 X10 User Manual

or another boat as this can cause an
overload of the boat’s electrical sys-
tem, resulting in signicant damage to
the boat that is not covered under the
warranty!
Attempting to jump start a battery or bat-
teries on a MasterCraf boat, regardless
of battery brand, from a vehicle or another
boat can cause an overload to the boat’s
electrical system, resulting in significant
damage to the electrical system. This is not
covered under warranty!
Ignition START-STOP
Models:
All models.
Purpose:
A START-STOP button is used to
start the engine after the ignition key
has been turned ON. The same START-
STOP button turns the engine OFF.
Location:
The START-STOP button is located
on the dash or driver’s armrest.
Operation:
The process for starting the boat is:
• Insert the key and turn. (This turns ON
the electrical system and prompts the
battery(ies) to provide power.)
• Turn the blower ON and allow it to
run for at least four (4) minutes before
starting the engine.
• Momentarily press the engine START-
STOP button.
• When it is time to turn the engine OFF,
press and hold for three (3) seconds
the START-STOP button. If the button
is held for less than three (3) seconds,
the engine will not turn OFF. This is
a system design to avoid shutting off
the engine if the button is inadvertently
pressed or hit during operation.
Special Attention:
NOTE: This button affects only the
engine. The electrical system will con-
tinue to operate as long as the key is
turned ON.
If the key is left turned in the ON
position after the outing, it will eventu-
ally run down the battery(ies) and the
engine and all systems will not start as
a result.
At the conclusion of the outing, turn
the key to the OFF position and remove
from the key slot. Doing so will ensure
that you have shut down the electrical
system, and it will prevent others from
starting or running the boat.
Troubleshooting:
If the key will not turn after being in-
serted in the key slot, it is likely to be
the wrong key. If the key turns but no
action happens, check the voltmeter for
a reading. If it is lower than 10.5 volts
Boat Operations • 2014 MasterCraft Owners Manual Page 4-9
B O A T O P E R A T I O N S

MasterCraft 2014 X10 Specifications

General

Brand	MasterCraft
Model	2014 X10
Category	Boat
Language	English