EasyManuals Logo

MasterCraft 2014 X10 User Manual

MasterCraft 2014 X10
285 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #250 background imageLoading...
Page #250 background image
Always be certain that the feet of individu-
als operating the trailer jack or in the vi-
cinity of the trailer jack are clear when the
jack is lowered into position. A considerable
amount of the trailer’s weight, and that of
the boat when it is aboard the trailer, can
be transferred through the trailer jack. This
could cause very painful injuries if feet are
not clear of the jack when it is lowered. Also
be certain that fingers and hands are clear
when moving the trailer jack because they
can be pinched in the mechanism, again re-
sulting in injury.
Tie Downs
Ensuring that a MasterCraft boat will be
held securely in place on the trailers hull
support (bunks), especially when under-
way, is extremely important. If the boat is
not rmly and properly secured, the boat
can be damaged as it bounces against the
hull supports.
MasterCraft’s Boat Buddy System is lo-
cated on the winch stand. Ask an autho-
rized MasterCraft dealer to demonstrate
the proper use of the Boat Buddy System. A
separate winch strap is provided and should
be attached to secure the boat to the bow
strap.
Also, it is very important to be sure that
the transom of the MasterCraft boat is rest-
ing fully and securely on the supports pro-
vided at the rear end of the trailer, and that it
remains in place when parked or underway.
Tie-down eyes have been added on both
the bow and transom of the boat and must
be used while trailering. Buckles at the
back of the trailer must also be secured to
the boat prior to towing.
Hitching Up
Hitch only to the ball size marked on the
coupler.
Be certain that the ball clamp captures
the ball and lever or that the hand wheel
is fully closed or tightened. Insert the
safety pin or optional lock pin.
Cross the safety cables under the cou-
pling.
Allow only enough slack in the safety
cables to handle turns. When hitching
the trailer up, always observe each item
on the Trailer Checklist found in this
Owners Manual. Hitching the trailer to
the tow vehicle may be performed by
just one person, but it is denitely easier
with a second person to help guide.
Here are the basic steps to hitch up to the
trailer:
Slowly back the tow vehicle as close as
possible to the trailer. It’s easier—and
safer—than pulling the trailer to the car
or truck.
Check to be sure the coupler locking de-
vice is released.
Raise the front end of the trailer with the
trailer jack, position the coupler directly
MasterCraft Trailers • 2014 MasterCraft Owners Manual Page 7-25
M A S T E R C R A F T T R A I L E R S

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the MasterCraft 2014 X10 and is the answer not in the manual?

MasterCraft 2014 X10 Specifications

General IconGeneral
BrandMasterCraft
Model2014 X10
CategoryBoat
LanguageEnglish

Related product manuals