MasterCraft 2112.1 User Manual

headline bars
continuation tabs
notes
warnings
headline bars
continuation tabs
notes
warnings
headline bars
continuation tabs
notes
warnings
11
headline bars
continuation tabs
notes
warnings
headline bars
continuation tabs
notes
warnings
headline bars
continuation tabs
notes
warnings
OPERATING INSTRUCTIONS
NOTICE: The microfilter should not be rinsed with water.
ATTACH THE VACUUM HOSE ( fig 3)
Directly attach the 1 1/4”(3.2 cm) vacuum hose to
the dust port, and then connect the opposite end of
the vacuum hose to a vacuum cleaner.
CLEAN AND EMPTY THE DUST CANISTER
(fig 4)
1. Remove the dust canister from the tool.
2. Hold the dust-canister body and remove the
microfilter by rotating it counter-clockwise.
3. Pour dust from the dust-canister body.
4. Knock excess dust out of the microfilter
or remove dust with a soft brush. You may
notice that all the dust may not come out of
the microfilter. This will not affect sanding
performance, but it will reduce dust collection
efficiency.
fig 4a
fig 3
fig 4b
WARNING!
• Collected sanding dust from sanding surface coatings such as polyurethanes, linseed oil, etc., can self-
ignite in the dust canister or elsewhere and cause fire. To reduce the risk of fire, always empty the dust
canister frequently while sanding and never store or leave a sander without totally emptying its dust box.
Also follow the recommendations of the coating manufacturers.
FPO
Microfilter
Dust-canister body
Dust port
1 1/4”(3.2 cm)
vacuum hose

MasterCraft 2112.1 Specifications

General

Brand	MasterCraft
Model	2112.1
Category	Sander
Language	English