headline bars
continuation tabs
notes
warnings
headline bars
continuation tabs
notes
warnings
headline bars
continuation tabs
notes
warnings
headline bars
continuation tabs
notes
warnings
headline bars
continuation tabs
notes
warnings
headline bars
continuation tabs
notes
warnings
model no. 054-7296-6 | contact us 1-800-689-9928
10
OPERATING INSTRUCTIONS
ATTACH THE SANDING PAPER
(fig 1)
1. Disconnect the sander from the power source.
2. Place the sander upside down on a flat surface.
3. Remove any dust or debris from the sanding pad.
4. Align the holes of the sanding paper with the holes in
the sanding pad and firmly press the sanding paper
against the sanding pad to ensure a good attachment.
5. To change the sanding paper, merely peel off the old
sanding paper, remove dust from the sanding pad, if
necessary, and press the new sanding paper in place as described above.
INSTALL THE MICROFILTER DUST
CANISTER
(fig 2)
Your sander is supplied with a dust canister to help
you keep the working area clean. The dust canister
is ideal for smaller jobs. For maximum efficiency, the
dust canister should be emptied frequently during
operation.
1. Disconnect the sander from the power source.
2. Align the slot on the dust canister with the rib on the
tool, and then push the dust canister onto the tool
until it locks into place.
REMOVE THE MICROFILTER DUST CANISTER
(fig 2)
1. Disconnect the sander from the power source.
2. Simply pull the dust canister away from the tool.
OPERATING INSTRUCTIONS
WARNING!
• Do not allow familiarity with the random orbit sander to cause a lack of alertness. A fraction of a second of
carelessness is enough to cause severe injury.
• Never connect the sander to the power source when you are assembling parts, making adjustments,
installing or removing sanding paper, cleaning, or when it is not in use. Disconnecting the sander will
prevent accidental starting, which could cause serious personal injury.
fig 1
fig 2
NOTICE: In order for the dust extraction system to operate properly, the holes in the pad must align with holes in the sanding
paper.
Sanding
paper
Rib
Microfilter dust canister
Sanding
pad
To Next Page
Loading...
Need help?
General
