LEFT/RIGHT HOLSTER POUCH
This multi-nailer is equipped with a holster
pouch that allows the user to conveniently
keep the tool and nails close at hand.
1. Slide the end of a large work belt (1)
through the holster pouch belt loop (2)
(Fig. 6).
2. Fasten the belt around your waist.
3. Position the holster on your hip for
convenient access to nails and the
tool.
LOADING A NAIL
You can load any of the following types of
nails into the multi-nailer:
1. Using your thumb, press the jaw
release button (1) (Fig. 7).
2. Position the nail (2) between the jaws
(3) and insert it into the opening until
the head of the nail makes contact
with the anvil, as shown in Fig. 8.
3. Remove your thumb from the jaw
release button to de-activate the jaws.
NOTE: The jaws will clamp onto the nail
head. If the nail is not tightly secured and
straight, press the jaw release button and
make sure the nail is properly aligned in
the jaws.
To Next Page
Loading...
