DRIVING A NAIL
Always drive a test nail in a scrap
workpiece of the same type as the good
workpiece. This action will verify the depth
setting and the most effective speed to
drive the nail.
While driving a test nail, experiment with
the speed. Generally, you will use lower
speeds to start nailing and for driving
larger nails into hardwoods.
For safety reasons, the operator
must read the sections of this
Owner’s Manual entitled “GENERAL
SAFETY WARNINGS”, “POWER
TOOL SAFETY”, “SPECIFIC SAFETY
RULES”, EXTENSION CORD
SAFETY” and “SYMBOLS” before
using this multi-nailer.
Verify the following every time the
multi-nailer is used:
1. Safety glasses and hearing
protection are being worn.
2. Area where nails are being
driven is free of any possibility
of “live” electrical wires.
3. Appropriate nails are being
used.
Failure to observe these safety rules
will significantly increase the risk of
injury.
To Next Page
Loading...
Need help?
General
