2017 OWNERS MANUAL / 148
UTILITIES
System Information
The System Settings screen displays the current software version
loaded on the unit. It is typically only accessed when the unit is
first installed in order to configure the unit. You can set individual
settings for the available options, or choose to select [RESTORE
DEFAULTS] for the factory settings.
BALLAST SETTINGS
Use the [NEXT] and [PREVIOUS] soft keys to navigate the settings.
Use the Save soft key to save the modified settings.
Settings Include:
AUTO BACKLIGHT—This setting enables and disables auto
backlighting feature. If enabled and the NAV Light is turned on, the
displays will reduce the screen brightness.
DAYTIME BRIGHTNESS—The daytime brightness control can be
set by using the [UP] and [DOWN] soft keys to change the settings
in five percent (5%) increments until the desired brightness is
achieved.
NIGHT TIME BRIGHTNESS—The night time brightness control
can be set by using the [UP] and [DOWN] soft keys to change
the settings in five percent (5%) increments until the desired
brightness is achieved.
AUDIO INTENSITY—The Audio Intensity feature allows you to set
values to automatically increase or decrease the audio volume
according to what speed you are traveling.
MINIMUM DEPTH—This allows you to choose a minimum depth
situation. Choosing zero turns this option OFF.
TROUBLESHOOTING
Display appears not to work or doesn’t come ON.
1. Display could be in sleep mode. Touch a key on the
keypad to activate the display.
2. Check for loose connections at battery and display unit.
3. Check for reversed polarity on the power connections.
4. Verify battery has a minimum voltage of 6 volts.
Display resets or goes OFF when starting engine.
1. Check display supply wires are connected properly to battery.
2. Verify battery is charged properly.
3. Check battery for ecient starter current.
Display has no back light.
Contact your MasterCraft service center.
Display has no keypad back light.
Contact your MasterCraft service center.