MasterForce 240-5239 - Blower Operation; Blower Operation Safety

Page 14
BLOWER OPERATION
This Wet/Dry Vac has blowing capabilities. To
use the blower feature follow the instructions
listed.
WARNING:
ALWAYS WEAR SAFETY
GOGGLES COMPLYING WITH ANSI Z87.1
(or in Canada, CSAZ94.3) BEFORE USING
BLOWER.
CAUTION:
KEEP BYSTANDERS
CLEAR FROM BLOWING DEBRIS.
WARNING:
WEAR A DUST MASK IF
BLOWING CREATES DUST THAT MIGHT BE
INHALED.
1. Verify that the power cord is disconnected
from the outlet. (fig. 1)
Fig. 1
2. Make sure the collection tank is empty
before using as a blower.
3. Remove hose from the vacuum port. (fig. 2)
Fig. 2
4. Insert the locking end of the hose into the
blower port on the back of the power head
and lock into position. (fig. 3)
Fig. 3
5. Fit the desired extension wand and or nozzle
to the vacuum hose. (fig. 4)
Fig. 4
6. Ensure the power switch is in the “O” OFF
position and plug in the power supply.
(fig. 5)
Fig. 5