Page 18
INSTALLING & CLEANING FOAM WET FILTER
Installing Foam Wet Filter
1. Verify that the power cord is disconnected
from the outlet. (fig. 1)
Fig. 1
2. Remove power head and place in upside
down position. Follow instructions to
remove cartridge filter in the section above.
3. Carefully slide foam wet filter down over
the filter cage making sure the cage is
completely covered. (fig. 2 & 3)
Fig. 2 Fig. 3
4. Place the power head onto the collection
tank.
Cleaning Foam Wet Filter
1. With the removed power head in an upside
down position, carefully remove foam wet
filter. (fig. 4)
Fig. 4
2. Use a mild soap and water solution to wash
foam wet filter and rinse with clean water.
(fig. 5)
Fig. 5
3. Allow filter to air dry before installing and
using again.
To Next Page
Loading...