Enter your 2-6 digit PIN within
30 seconds and press the
ENTER button.
Look in the box for:
"It is recommended to program and test the keypad before mounting."
Wireless
keypad*
2 x Lag Screws
#6 x 1-3/8"
2 x Anchors
To prevent SERIOUS INJURY or DEATH:
• Keep remote control and battery out of reach of
children.
• Never permit children to access the door control or
remote control.
• Operate door ONLY when it is adjusted properly with
no obstructions to door travel and is in clear sight.
• ALWAYS keep a moving door in sight until
completely closed. NO ONE should cross the path
of a moving door.
To reduce risk of fire, explosion or electric shock:
• DO NOT short circuit, recharge, disassemble or
heat battery.
• Replace with 2 x AAA batteries ONLY. Dispose of
batteries properly.
1. Press and release the “Learn” button.
2. The “OK” LED will illuminate
indicating ready for programming.
3. Garage door opener is ready to accept
PIN within the next 30 seconds.
"OK" LED will flash and beep
twice indicating code is set.
30 sec
Press and hold LEARN for 3 seconds
Erasing ALL remote controls from memory:
To erase ALL remote controls from memory, press
and hold “Learn” button for 3 seconds. “OK”
LED will flash and beep three times indicating all
remotes have been erased from memory.
Wireless keypad may be secured on door jamb
outside your garage. Install keypad within sight
of door at minimum height of 5 feet (1.5 m). Test
the range of the keypad before mounting. Find an
alternative mounting location if range is insufficient.
2 x beeps
2 x flashes
2 x beeps
Press and release LEARN
Beeps
30 sec
WARNING
23 masterforceopeners.com Customer Service: 1-877-436-4402
To Next Page
Loading...