MasterForce 270-1157 - Operation

Page 12
WARNING
Wear eye protection
during operation.
TURBO
TURBO
Start handle
Start button
Battery capacity indicator
Turbo button
8
1. Make sure safety key is inserted into slot.
2. Push and hold the start button
3. While you hold the start button, grab the start
handles in the direction of the handle bar.
4. Once the machine has started, you can
release the start button.
5. Press the Turbo button to speed up to 3,200
RPM.
Battery capacity indicator
- Light - Capacity
- 4
Green
Lights
- The battery is above 80%
capacity
- 3
Green
Lights
- The battery is between
80% and 60% capacity
- 2
Green
Lights
- The battery is at between
60% and 40% capacity
- 1
Green
Lights
- The battery is between
40% and 20% capacity
- Lights
go out
- The battery is less
than 20% capacity and
requirescharging immediately
1. Release the start handle to stop the
machine.
Wait until the
blade fully stops
before you start
the machine again. Do not quickly turn the
machine off and on.
WARNING
Always remove the
safety key and
battery pack after you complete the work.
TURBO
Start handle
Start button
9
Self-propel
drive lever
Speed
control
1. Start the machine.
2. While you hold the start handles, grab either
of the drive levers and pull towards the
handle bar.
3. Hold the start handles and the drive levers
at the same time.
4. Release either set of start handle and drive
lever from the same side.
5. Adjust the speed control with your free
hand.
• Slide the speed control button in the
direction of the Rabbit Symbol to
increase the speed.
• Pull the speed control button in the
direction of the Turtle Symbol to
decrease the speed.
6. Release the drive levers to close the self-
propel system.
To engage the self-propel drive system
while the mower is not running:
• Press and hold the start button, then pull up
on the drive lever.
OPERATION
WARNING