MasterForce 270-1157 - Troubleshooting

Page 16
PROBLEM POSSIBLE CAUSE SOLUTION
The handle is not in
position.
The bolts are not
engaged correctly.
Adjust the height of the handle and make sure
that the bolts and nuts are aligned correctly.
The machine does
not start.
The battery capacity
is low.
Charge the battery pack.
The start handle is
defective.
Replace the start handle.
The battery key is not
put in.
Put in the battery key.
The machine cuts
grass unevenly.
The lawn is rough. Examine the mowing area.
The blade height is
not set correctly.
Move the wheels to a higher position.
The machine does
not mulch correctly.
Wet grass clippings
attach to the deck.
Wait until the grass dries before mowing.
The mulch plug is
missing.
Install the mulch plug.
The machine is
hard to push.
The grass is too tall,
or the blade height is
too low.
Increase the blade height.
The grass catcher
and the blade drags
in thick grass.
Empty the grass clippings from the grass
catcher.
There is a high
vibration in the
machine.
The blade is
unbalanced and worn.
Replace the blade.
The motor shaft is
bent.
1. Stop the motor.
2. Remove the safety key and battery pack.
3.Disconnect the power source.
4. Inspect for damage.
5. Repair the machine before you start it again.
The machine stops
during mowing.
The blade height is
too low.
Increase the blade height.
The battery pack is
out of power.
Charge the battery pack.
The grass clippings
attach to the deck or
the blade.
Remove the battery pack and check the deck.
Operation
temperature of the
machine is too high.
Cool the machine.
TROUBLESHOOTING