STORAGE AND TRANSPORT
• ALWAYS store the tile saw in a dry place.
• Store the tile saw in a frost-free place.
• Protect the tile saw from damage during transport.
• Keep the tile saw away from children. Store the tile saw
in a place where it is safe from children and unauthorized
persons.
USE DUST MASK
Some dust created by sawing contains chemicals that are
known to cause cancer, birth defects or other reproductive
harm. To reduce exposure to these chemicals, work in a
well-ventilated area with approved safety equipment, such
as dust masks that are specially designed to lter out
microscopic particles.
POSITION OF TILE SAW
• To avoid the possibility of the appliance plug or receptacle
getting wet, position tile saw to one side of a wall-mounted
receptacle to prevent water from dripping onto the
receptacle or plug. The user should arrange a "drip loop"
in the cord connecting the saw to a receptacle. The "drip
loop" is the part of the cord below the level of the
receptacle, or the connector if an extension cord is used,
to prevent water traveling along the cord and coming into
contact with the receptacle.
• If the plug or receptacle does get wet, DO NOT unplug
the cord. First, disconnect the fuse or circuit breaker that
supplies power to the tile saw. Then unplug and examine
for presence of water in the receptacle.
INJURY RISKS
Even when the tile saw is used properly and in compliance
with all the safety precautions in these instructions, the
following residual risks can arise:
• Touching the tile saw blade in the exposed area.
• Reaching into the spinning tile saw blade.
• Ejection of cut pieces.
• Serious injury resulting from failure to wear required safety
protection.
manufacturer.
• Use only diamond tile saw blades for which the maximum
possible speed is not less than the maximum spindle
speed of the tool and the material to be cut.
• Maximum size of working piece should be 24" length and
24.5" width.
• This tile saw should be used at an ambient temperature
between 59-80°F (15-50°C).
• USE PROPER EXTENSION CORD. Make sure your
extension cord is in good condition. When using an
extension cord, be sure to use one heavy enough to carry
the current your product will draw. An undersized cord will
cause a drop in line voltage, resulting in loss of power and
overheating. The chart on Page 6 shows the correct size
to use depending on cord length and nameplate ampere
rating. If in doubt, use the next heavier gauge. The smaller
the gauge number, the heavier the cord.
SAFETY INSTRUCTIONS
READ OPERATOR’S MANUAL
To reduce the risk of injury, user must read and
understand operator’s manual before using this tile saw.
Page 5
WARNING: For your own safety, read instruction
manual before operating tile saw.
WARNING: The tile saw is loud and the sound can
cause hearing damage. ALWAYS wear ear protection to
help prevent hearing damage and loss. Failure to comply
may result in injury.
FIG. 1
• Wear eye protection.
• Use splash guard for every operation for which it can be
used.
• Disconnect tile saw before servicing, when changing tile
saw blades, and cleaning.
• Use tile saw only with diamond tile saw blades.
• Replace damaged tile saw blade before operating.
• DO NOT ll water tank above water ll line.
• USE SAFETY GOGGLES AND EAR PROTECTION
• ALWAYS WEAR EYE PROTECTION THAT CONFORMS
WITH UL REQUIREMENTS. FLYING DEBRIS can cause
permanent eye damage.
Drip loop
To Next Page
Loading...
