To Next PageTo Next PageWhat to do if the motor stops turning on my MasterForce Saw?
If the motor of your MasterForce Saw stops turning, ensure all electrical connections are secure. Also, verify that the power source voltage is 120 V and that the switch is in the "ON" position.
Why is the laser line projection hard to see on my MasterForce 709-3912?
If the laser line projection on your MasterForce Saw is hard to see, try dimming the lights in your work area. Also, check the aperture cover for any dust or water and clean it off.
What to do if the pump cannot inject water in my MasterForce Saw?
If the pump on your MasterForce Saw cannot inject water, first ensure there's enough water in the tray. Next, check that the water hose is firmly attached and the pump's electrical cord is securely connected to the receptacle. Finally, remove the foam filter, rinse it, and replace it in the pump.
General| Brand | MasterForce |
|---|---|
| Model | 709-3912 |
| Category | Saw |
| Language | English |
