MasterForce 709-3912 - Brush Replacement

WARNING: When servicing, use only identical Masterforce replacement parts. Use of any other parts may create a
hazard or cause product damage. ALWAYS wear eye protection with side shields marked to comply with ANSI Z87.I during
product operation. If operation is dusty, also wear a dust mask. DO NOT at any time let brake uids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact with plastic parts. Chemicals can damage, weaken or destroy plastic
which may result in serious personal injury.
Page 28
Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from various types of commercial
solvents and may be damaged by their use. Use clean cloths to remove dirt, dust, oil, grease, etc.
LUBRICATION
All of the bearings in this tile saw are lubricated with a sufcient amount of high grade lubricant for the life of the unit under
normal operating conditions. After extended use, clean the rails so the table will slide smoothly.
CLEANING THE TILE SAW
• Unplug the tile saw and water pump.
• Empty the dirty water from the water tray and replace with clean water.
• Rinse off the sliding table.
• Unlock table stop (turning until the slot is vertical).
• Grasp the table rmly before pulling the table to the front and off the tile saw.
• Once the table has been removed, rinse the rails and water tray frame.
• Empty dirty water from the water tray and dry off the tile saw.
CLEANING THE RAILS
• During use, the rails will become dirty, preventing the table rollers from sliding smoothly. It is important to clean the rails
often.
CLEANING THE SUBMERSIBLE PUMP
• Unplug pump before handing or cleaning the pump.
• Remove the front cover.
• Using a small brush and/or water, clean any debris or trash that is trapped on the side of the pump.
If the pump will not run, try the following solutions:
• Ensure that the intake screen is free of obstruction.
• Make sure that the water hose isn’t clogged or knotted.
• Be sure the unit is plugged into a functioning power outlet.
• Be sure there is adequate water in the water tank
MAINTENANCE
CAUTION: To maintain efciency and extend the life of the pump, check intake screen before use to make sure
it is clean.
CAUTION: To prevent accidental starting, do not handle the pump while it is connected to a power source.