Page 13
CARE AND MAINTENANCE
Storage
• When your pressure washer session has
been completed, turn off the power switch.
Unplug the power cord from the outlet. Turn
off the water supply. Pull the trigger on the
spray gun 2-3 seconds to drain out the
excess water and to release any remaining
water pressure. Do not allow the pressure
washer to run with no water flowing through
it.
• Remove high pressure hose from spray
gun and unscrew the other end of the high
pressure hose from the pressure washer.
• The high pressure hose is stored on the
hose hook located on the back of the handle.
• Insert extension lance into nozzle tray, and
press spray gun with extension lance into
spray gun holster.
• Make sure to discard any remaining
detergent from the foam cannon. Residual
chemical will stick to the container which
could become contaminated and can cause
the foam cannon injector to clog and not
function properly. Flush the foam cannon
and nozzles with clear water to prevent
clogging.
• The quick connect nozzles are stored on the
nozzle holder located on the spray gun.
• Put the rotary nozzle on the rotary nozzle
holder located on the right of the pressure
washer.
• Store the foam cannon on the back of the
pressure washer.
• Wind the power cord around the cord hooks
located on the back of the pressure washer.
•
DO NOT store the pressure washer where
it is exposed to freezing temperatures
unless you use an antifreeze designed
for pumps.
Store the pressure washer
indoors to prevent the water in the unit
from expanding under freezing conditions.
When the water freezes and expands, your
pressure washer will be damaged and
become inoperable. Or, if storing outdoors,
it is recommended you use pump saver (not
included) to protect pumps.
96048_IM_MFX2U2200.indd 1396048_IM_MFX2U2200.indd 13 2020/12/10 上午10:402020/12/10 上午10:40
To Next Page
Loading...
