Need help?Do you have a question about the Mastervolt Chargemaster 24/100-3 and is the answer not in the manual?
General| Output Voltage | 24 V DC |
|---|---|
| Output Current | 100 A |
| Number of Outputs | 3 |
| Protection Degree | IP21 |
| Battery Types | Lithium-ion |
| Protection | short circuit |
| Cooling | Fan |
| Input Voltage | 230 V (180-265 V) 50/60 Hz |
Provides crucial safety warnings and precautions when working with lead-acid batteries.
Warns about risks of explosive gases around lead-acid batteries during operation and charging.
Explains the three-stage charging process (Bulk, Absorption, Float) for optimal battery charging.
Describes how fault conditions are indicated on the display and the general cause.
Details AC wiring requirements, including wire cross-sections and colour coding for different voltages.
Continues the step-by-step guide for installing the Chargemaster.
Specifies DC wiring requirements, including cable cross-sections, colour coding, and connection points.
Provides critical warnings and notes for connecting the charger to the electrical system and batteries.
Explains the process of commissioning the charger after installation, including settings and checks.
Provides critical safety warnings and guidelines for AC and DC wiring.
Covers general commissioning steps, factory settings, and polarity checks before operation.
Emphasizes the importance of AC safety grounding and residual current devices.
Explains the function and configuration of the four DIP switches on the housing for basic settings.
Lists configurable parameters and their ranges for specific 24V Chargemaster models.
Lists configurable parameters and their ranges for specific 12V Chargemaster models.
Warns about and explains the use of the equalize mode via DIP-switch 4 for specific battery types.
Provides rules and diagrams for setting up a MasterBus network using patch cables and terminating devices.
Explains how to monitor and program the Chargemaster via the MasterBus interface.
To Next Page