24 November 2004 / WHISPER 6 / 12 Mobile / EN
EVERY 1000 HOURS:
• Replace the V-belt.
• Retighten cylinder head bolts/adjust +
valve clearance.
• Check and clean the vadiators.
EVERY 2000 HOURS:
• Check lubricating oil pressure
• Clean and check or replace fuel injector nozzles
and check injection pressure.
• Check the air filter element:
The air is taken in via the cover on the alternator.
Below this cover is a spongy material which filters
the air and holds some electrical components
which are cooled by the inlet air. This filter does
not require regular maintenance. Only in very
dusty circumstances this filter should be cleaned.
The spongy material can be washed in solvent or
replaced.
When the generator set runs less than 100
hours a year the oil should be changed
yearly.
4.3.1 Maintenance schedule
4.3.2 Putting out of service
When not using the generator for a longer period it is re-
commended to execute an engine preservation procedure.
1 Clean the engine.
2 Loosen the fuel suction pipe and fuel return and put
them in a can with preservation diesel fuel. Start the
engine and run the engine warm.
3 Drain the hot engine oil and refill with preservation oil.
4 The coolant can stay in the engine and radiators.
5 Disconnect the battery and store it in a place dry and
free of frost and charge it regularly.
6 Close inlet- and outlet openings with tape.
7 Protect the generating set against the influences of
bad weather conditions.
This way of preservation will be sufficient for 6 months.
Repeat step 2, 3, and 4, every 6 months. Change oil
before using the engine again.
Check oil level daily
Check the level of the cooling liquid daily
Retighten cylinderhead bolts , change oil, replace oil filter
and readjust valve clearance after first 50 hours
Changing oil 150 hours
Check and readjust V-belt 150 hours
Replace the oil filter 300 hours
Check impeller waterpump 300 hours
Checking valve clearance 300 hours
Replacing fuel filter 300 hours
Replace impeller waterpump 500 hours
Clean radiator with compressed air 1000 hours
Retighten cylinder head bolts, adjust valve
clearance 1000 hours
Replace the V-belt 1000 hours
Check injector and injection pressure 2000 hours
Check inlet air filter 2000 hours
To Next Page
Loading...
Need help?
General
